Hello everyone,

This article is designed to assist all M6 HD controller users in calibrating the gyroscope,Six-Axis Motion Sensing, and resolving joystick drift issues. We have developed a standardized calibration method to ensure the most accurate sensor readings and optimal performance.

By following the steps outlined below.

Press L1+up+ cap on the left handle to turn on the device, press R1+X+HOME on the right handle, the two LEDs flash alternately, turn the joystick to the maximum edge, then insert the handle into the host (do not insert it to the bottom) and place it flat on the table, press "-" on the left handle and "+" on the right handle to complete the sensor calibration. Take out the handle, and the two LEDs do not flash, then the calibration is complete.

Note: Use a round wear-resistant ring for calibration.